I was wondering where I could locate the fiberglass wrapped rods to make rollbars for my prototyping/test Quartz. I am not sure what size either. Looks to be a possible 3mm diameter but not sure. Haven't seem to find any sites that sell the rods or have much info. If anyone can help with specifications, parts list or vendors that would help greatly. I will continue searching.
I was bored today and was actually tired of snags from yoyo based tricks and decided to mod/practice on the Quartz again before applying to actual builds and did a snagless setup on it today. I saw this on a Benson DS/Gemini. It was a crude/fast install but worked well enough today. Please excuse the Mylar alternative Dacron reinforcement that was sewn on the front of the kite rather than the rear. Figured if the black was going to bleed through the sail might as well just place it up front.